Starting generation of Calibration File 
FS version = 0009.0011.0019 
time_zero = 4449600 
Found #48 errors of type = ERROR qk -211 Tsys value for device ic overflowed or was less than zero. 
Found #24 errors of type = ERROR fl   -1 Previous source in this schedule not reached before new source was commanded 
Found #12 errors of type = ERROR an  -11 An antenna SYPARM routine failed. 
Found #12 errors of type = ERROR qo -301 WARNING: ONSOURCE status is SLEWING! 
Found #12 errors of type = ERROR an -103 Pointing computer tracking errors are too large. 
Found #6 errors of type = ERROR 5k  302 There have not been two scan_name ... commands since the schedule started  use scan_check force to force check 
Found #5 errors of type = ERROR an   -5 Error return from antenna. 
Found #4 errors of type = ERROR bo -262 Cannot change schedules while recording  use disk_record off to stop. 
Found #3 errors of type = ERROR qk -211 Tsys value for device au overflowed or was less than zero. 
Found #2 errors of type = ERROR an  -12 Antenna parameter mismatch - try re-issue 'source ' command to reset. 
Found #2 errors of type = ERROR sp   -4 Unrecognized name (not a function or procedure). 
Found #1 errors of type = ERROR fm   -1 Opening file:  usr2 proc r128hh.prc 
Found #1 errors of type = ERROR bo -133 Error opening procedure library  UNIX    2: No such file or directory 
Found these BBCs:   
NBBC: 0
Found these  parameters:   
RX1 min= 100000 max= -1
RX2 min= 100000 max= -1
RX3 min= 100000 max= -1
Plotting 0 Tsys channels:   
Tsys values are: 3 4 -1 etc
NTSYS: 0