Starting generation of Calibration File 
FS version = 0009.0011.0002 
time_zero = 29869200 
Found #288 errors of type = ERROR qk -211 Tsys value for device va overflowed or was less than zero. 
Found #288 errors of type = ERROR qk -211 Tsys value for device i2 overflowed or was less than zero. 
Found #208 errors of type = ERROR qk -211 Tsys value for device ve overflowed or was less than zero. 
Found #96 errors of type = ERROR qk -211 Tsys value for device v9 overflowed or was less than zero. 
Found #36 errors of type = ERROR qo -301 WARNING: ONSOURCE status is SLEWING! 
Found #8 errors of type = ERROR qk -211 Tsys value for device vd overflowed or was less than zero. 
Found #6 errors of type = ERROR ch   -4 Device vf timed-out on response from MATCN 
Found #5 errors of type = ERROR ma   -4 Device vf timed-out on response. 
Found #3 errors of type = ERROR ch -302 vf frequency does not check with requested value 
Found #3 errors of type = ERROR ch -304 vf TPI selection does not check with requested setting 
Found #3 errors of type = ERROR ch -303 vf bandwidth does not check with requested value 
Found #3 errors of type = ERROR ch -309 vf alarm is on 
Found #2 errors of type = ERROR ch -307 vf unlock indicator is on 
Found #1 errors of type = ERROR qo   -1 No parameters permitted for track command. 
Found #1 errors of type = ERROR st -110 [ANTCN] - Source is out from antenna elevation range. 
Found #1 errors of type = ERROR st -115 [ANTCN] - WARNING: X S paths are not in line. 
Found #1 errors of type = ERROR qk -211 Tsys value for device i3 overflowed or was less than zero. 
Found #1 errors of type = ERROR qk -211 Tsys value for device v4 overflowed or was less than zero. 
Found #1 errors of type = ERROR ch -305 vf USB attenuator does not check with requested setting 
Found #1 errors of type = ERROR qk -211 Tsys value for device v5 overflowed or was less than zero. 
Found #1 errors of type = ERROR ch -306 vf LSB attenuator does not check with requested setting 
Found #1 errors of type = ERROR qk -211 Tsys value for device v6 overflowed or was less than zero. 
Found these BBCs: vc01 vc05 vc09
NBBC: 3
Found these  parameters:   
RX1 min= 100000 max= -1
RX2 min= 100000 max= -1
RX3 min= 100000 max= -1
Plotting 3 Tsys channels: 01 05 09
Tsys values are: 3 4 -1 etc
NTSYS: 3
in match_chan ft1=  nt1=  st1=  tt= 
set scale tsys1 [2] min max 55.9 305
set scale tsys2 [2] min max  
set scale tsys3 [2] min max  
set scale tsys4 [2] min max  
 Tsys scale ymin -5 ymax 5