Starting generation of Calibration File 
FS version = 0009.0010.0000 
time_zero = 27968400 
Found #1121 errors of type = ERROR qo -302 WARNING: ANTCN not being run  antenna device is  dev null. 
Found #561 errors of type = ERROR qi -302 Last commanded IFD attenuations used as default  please modify command. 
Found #561 errors of type = ERROR qs -306 WARNING: ANTCN not being run  antenna device is  dev null. 
Found #181 errors of type = ERROR sc  -13 setcl: formatter to FS time difference 0.5 seconds or greater 
Found #70 errors of type = ERROR m5 -104 mk5cn: time-out on mk5 device  connection closed 
Found #12 errors of type = ERROR m5  -21 mk5cn: error connect(): mk5 device connection open timed-out 
Found #11 errors of type = ERROR ch -311 IF distributor is not in remote 
Found #10 errors of type = ERROR un  115 Operation now in progress 
Found #10 errors of type = ERROR m5  -23 mk5cn: socket open error from getsockopt() 
Found #4 errors of type = ERROR sc  -10 setcl: failed too many times  couldn't check formatter time 
Found #3 errors of type = ERROR m5 -906 MARK5 return code 6: inconsistent or conflicting request 
Found #2 errors of type = ERROR bo -304 This error already in TNX list  so it is already 'off'. 
Found #1 errors of type = ERROR m5 -900 Already off 
Found #1 errors of type = ERROR m5 -900 Can't read while data transfer in progress 
Found #1 errors of type = ERROR m5 -900 No scans 
Found #1 errors of type = ERROR bo -173 Disk recording was commanded  either use disk_record off or terminate disk_record_ok. 
Found these BBCs: vc01 vc05 vc09
NBBC: 3
Found these  parameters:   
RX1 min= 100000 max= -1
RX2 min= 100000 max= -1
RX3 min= 100000 max= -1
Plotting 3 Tsys channels: 01 05 09
NTSYS: 3
in match_chan ft1=  nt1=  st1=  tt= 
set scale tsys1 [2] min max  
set scale tsys2 [2] min max  
set scale tsys3 [2] min max  
set scale tsys4 [2] min max  
 Tsys scale ymin -5 ymax 5