Starting generation of Calibration File 
FS version = 0009.0009.0002 
time_zero = 22762800 
Found #386 errors of type = ERROR qk -211 Tsys value for device ve overflowed or was less than zero. 
Found #13 errors of type = ERROR st -100 invalid time in antenna message - antenna protocol error. 
Found #13 errors of type = ERROR ch -302 v6 frequency does not check with requested value 
Found #11 errors of type = ERROR ch -308 ve total power integrator overflow 
Found #6 errors of type = ERROR ch -309 v9 alarm is on 
Found #2 errors of type = ERROR qk -211 Tsys value for device v9 overflowed or was less than zero. 
Found #2 errors of type = ERROR sc  -13 setcl: formatter to FS time difference 0.5 seconds or greater 
Found #1 errors of type = ERROR ch -312 IF1 attenuator does not check with requested value 
Found #1 errors of type = ERROR ch -362 IF3 attenuator does not check with requested value. 
Found #1 errors of type = ERROR qo -301 WARNING: ONSOURCE status is SLEWING! 
Found #1 errors of type = ERROR ch -313 IF2 attenuator does not check with requested value 
Found these BBCs: vc01 vc05 vc09
NBBC: 3
Found these  parameters:   
RX1 min= 100000 max= -1
RX2 min= 100000 max= -1
RX3 min= 100000 max= -1
Plotting 3 Tsys channels: 01 05 09
Tsys values are: 1 2 3 etc
NTSYS: 3
in match_chan ft1= r4294sv.log.tsy1.ntup nt1= 7 st1= 1d tt= 1
set scale tsys1 [2] min max 39.2 305
set scale tsys2 [2] min max  
set scale tsys3 [2] min max  
set scale tsys4 [2] min max  
 Tsys scale ymin 32.2 ymax 305 
in match_chan ft1= r4294sv.log.tsy1.ntup nt1= 19 st1= 5u tt= 1
set scale tsys1 [2] min max 39.2 305
set scale tsys2 [2] min max  
set scale tsys3 [2] min max  
set scale tsys4 [2] min max  
 Tsys scale ymin 38.4 ymax 305 
in match_chan ft1= r4294sv.log.tsy1.ntup nt1= 12 st1= 9u tt= 1
set scale tsys1 [2] min max 39.2 305
set scale tsys2 [2] min max  
set scale tsys3 [2] min max  
set scale tsys4 [2] min max  
 Tsys scale ymin 68.4 ymax 305