Starting generation of Calibration File 
FS version = 0009.0009.0002 
time_zero = 22788000 
Found #51 errors of type = ERROR ch -317 Total power integrator overflow on IF2 
Found #12 errors of type = ERROR qk -211 Tsys value for device i2 overflowed or was less than zero. 
Found #10 errors of type = ERROR ch -308 v9 total power integrator overflow 
Found #6 errors of type = ERROR qo -301 WARNING: ONSOURCE status is SLEWING! 
Found #6 errors of type = ERROR an -103 Pointing computer tracking errors are too large. 
Found #2 errors of type = ERROR qk -211 Tsys value for device v9 overflowed or was less than zero. 
Found #2 errors of type = ERROR ch -311 IF distributor is not in remote 
Found #2 errors of type = ERROR qk -211 Tsys value for device i1 overflowed or was less than zero. 
Found #2 errors of type = ERROR sp   -4 Unrecognized name (not a function or procedure). 
Found #1 errors of type = ERROR ib   -4 GPIB Device time-out on response ca 
Found #1 errors of type = ERROR qd -301 Synch block CRC checksum test FAILED. 
Found these BBCs: vc01 vc05 vc09
NBBC: 3
Found these RX parameters: 02(LO) 03(DCAL) 0E(LO5MHZ)
RX1 min= 44.50 max= 45.84
RX2 min= 39.49 max= 40.84
RX3 min= 0.150 max= 0.152
Plotting 3 Tsys channels: 01 05 09
Tsys values are: 1 2 3 etc
NTSYS: 3
in match_chan ft1= r4294ft.log.tsy1.ntup nt1= 7 st1= 1d tt= 1
set scale tsys1 [2] min max 65.1 109.2
set scale tsys2 [2] min max  
set scale tsys3 [2] min max  
set scale tsys4 [2] min max  
 Tsys scale ymin 62.4 ymax 119 
in match_chan ft1= r4294ft.log.tsy1.ntup nt1= 19 st1= 5u tt= 1
set scale tsys1 [2] min max 65.1 109.2
set scale tsys2 [2] min max  
set scale tsys3 [2] min max  
set scale tsys4 [2] min max  
 Tsys scale ymin 54.9 ymax 102.7 
in match_chan ft1= r4294ft.log.tsy1.ntup nt1= 12 st1= 9u tt= 1
set scale tsys1 [2] min max 65.1 109.2
set scale tsys2 [2] min max  
set scale tsys3 [2] min max  
set scale tsys4 [2] min max  
 Tsys scale ymin 0.4 ymax 305