Starting generation of Calibration File 
FS version = 0009.0009.0002 
time_zero = 3344400 
Found #9 errors of type = ERROR qk -211 Tsys value for device i2 overflowed or was less than zero. 
Found #2 errors of type = ERROR sp   -4 Unrecognized name (not a function or procedure). 
Found #1 errors of type = ERROR qo -301 WARNING: ONSOURCE status is SLEWING! 
Found #1 errors of type = ERROR st  -14 Antenna stuck.
 
Found #1 errors of type = ERROR qd -301 Synch block CRC checksum test FAILED. 
Found #1 errors of type = ERROR an -103 Pointing computer tracking errors are too large. 
Found these BBCs: vc01 vc05 vc09
NBBC: 3
Found these RX parameters: 02(LO) 03(DCAL) 0E(LO5MHZ)
RX1 min= 45.23 max= 46.45
RX2 min= 40.23 max= 41.33
RX3 min= 0.150 max= 0.152
Plotting 3 Tsys channels: 01 05 09
Tsys values are: 1 2 3 etc
NTSYS: 3
in match_chan ft1= ohig48ft.log.tsy1.ntup nt1= 7 st1= 1d tt= 1
set scale tsys1 [2] min max 120.3 271.4
set scale tsys2 [2] min max  
set scale tsys3 [2] min max  
set scale tsys4 [2] min max  
 Tsys scale ymin 113.4 ymax 278.2 
in match_chan ft1= ohig48ft.log.tsy1.ntup nt1= 19 st1= 5u tt= 1
set scale tsys1 [2] min max 120.3 271.4
set scale tsys2 [2] min max  
set scale tsys3 [2] min max  
set scale tsys4 [2] min max  
 Tsys scale ymin 113.3 ymax 270.3 
in match_chan ft1= ohig48ft.log.tsy1.ntup nt1= 12 st1= 9u tt= 1
set scale tsys1 [2] min max 120.3 271.4
set scale tsys2 [2] min max  
set scale tsys3 [2] min max  
set scale tsys4 [2] min max  
 Tsys scale ymin 73.2 ymax 242.7