Starting generation of Calibration File 
FS version = 0009.0009.0002 
time_zero = 30787200 
Found #26 errors of type = ERROR qk -211 Tsys value for device i2 overflowed or was less than zero.
 
Found #20 errors of type = ERROR ch -317 Total power integrator overflow on IF2
 
Found #10 errors of type = ERROR qo -301 WARNING: ONSOURCE status is SLEWING!
 
Found #4 errors of type = ERROR qk -211 Tsys value for device vc overflowed or was less than zero.
 
Found #2 errors of type = ERROR qk -211 Tsys value for device v6 overflowed or was less than zero.
 
Found #2 errors of type = ERROR qk -211 Tsys value for device v3 overflowed or was less than zero.
 
Found #2 errors of type = ERROR qk -211 Tsys value for device v1 overflowed or was less than zero.
 
Found #2 errors of type = ERROR qk -211 Tsys value for device va overflowed or was less than zero.
 
Found #2 errors of type = ERROR qk -211 Tsys value for device vd overflowed or was less than zero.
 
Found #2 errors of type = ERROR qk -211 Tsys value for device i1 overflowed or was less than zero.
 
Found #2 errors of type = ERROR qk -211 Tsys value for device v5 overflowed or was less than zero.
 
Found these BBCs: vc06
 vc11
 
NBBC: 2
Found these RX parameters: front
 rear
 lo
RX1 min= 100000 max= 2007.356.10:05:04.48
RX2 min= 100000 max= -1
RX3 min= 100000 max= -1
Plotting 2 Tsys channels: 06 11 
Tsys values are: 1 2 3 etc
NTSYS: 2
in match_chan ft1= crfs11ho.log.tsy1.ntup nt1= 20 st1= 6u tt= 1
set scale tsys1 [2] min max 55.9 305
set scale tsys2 [2] min max  
set scale tsys3 [2] min max  
set scale tsys4 [2] min max  
 Tsys scale ymin 43.8 ymax 305 
in match_chan ft1= crfs11ho.log.tsy1.ntup nt1= 14 st1= bu tt= 1
set scale tsys1 [2] min max 55.9 305
set scale tsys2 [2] min max  
set scale tsys3 [2] min max  
set scale tsys4 [2] min max  
 Tsys scale ymin 53.8 ymax 305