Starting generation of Calibration File 
FS version = 0009.0007.0000 
time_zero = 10170000 
Found #78 errors of type = ERROR AN -103 Pointing computer tracking errors are too large. 
Found #78 errors of type = ERROR qo -301 WARNING: ONSOURCE status is SLEWING! 
Found #7 errors of type = ERROR ch -233 r1 tape drive should be moving and it isn't 
Found #6 errors of type = ERROR ST   -9 Antenna is in MANUAL mode. 
Found #6 errors of type = ERROR ST   -6 Antenna brakes are ON. 
Found #3 errors of type = ERROR qg -303 Track 29 parity errors exceed threshold. 
Found #2 errors of type = ERROR sp   -4 Unrecognized name (not a function or procedure). 
Found #2 errors of type = ERROR st -902 
Found #2 errors of type = ERROR qg -303 Track 22 parity errors exceed threshold. 
Found #2 errors of type = ERROR st -903 
Found #1 errors of type = ERROR qg -303 Track 18 parity errors exceed threshold. 
Found #1 errors of type = ERROR sp   -3 More than 12 characters in function or procedure name. 
Found #1 errors of type = ERROR qg -305 AUX data differs from expected value on track  8. 
Found #1 errors of type = ERROR ib   -4 GPIB Device time-out on response ca 
Found these BBCs: bbc01 bbc05 bbc09
NBBC: 3
Found these RX parameters: 00(front) 02(lo) 03(dcal)
RX1 min= 24.73 max= 27.90
RX2 min= 45.97 max= 46.58
RX3 min= 50.98 max= 51.34
Plotting 3 Tsys channels: 01 05 09
Tsysa values are:    etc
Tsysb values are:    etc
Tsysc values are:    etc
Tsysd values are:    etc
NTSYS: 3
in match_chan ft1=  nt1=  st1=  tt= 
set scale tsys1 [2] min max  
set scale tsys2 [2] min max  
set scale tsys3 [2] min max  
 Tsys scale ymin 0 ymax 100