Starting generation of Calibration File 
FS version = 0009.0007.0007 
time_zero = 19324800 
Found #59 errors of type = ERROR ib   -4 GPIB Device time-out on response ca 
Found #56 errors of type = ERROR st   -4 Interface not set to remote. 
Found #6 errors of type = ERROR qo -301 WARNING: ONSOURCE status is SLEWING! 
Found #6 errors of type = ERROR an -103 Pointing computer tracking errors are too large. 
Found #5 errors of type = ERROR ch -309 v2 alarm is on 
Found #4 errors of type = ERROR qk -211 Tsys value for device i2 overflowed or was less than zero. 
Found #3 errors of type = ERROR ma   -4 Device sk timed-out on response. 
Found #2 errors of type = ERROR st   -7 Antenna off-source! 
Found #2 errors of type = ERROR ch -370 Total power integrator overflow on IF3 
Found #2 errors of type = ERROR st   -6 Antenna control restored. 
Found #1 errors of type = ERROR qk -211 Tsys value for device v3 overflowed or was less than zero. 
Found #1 errors of type = ERROR st   -5 Error return from antenna. 
Found #1 errors of type = ERROR 4f -501 Formatter was failing the synch test. 
Found #1 errors of type = ERROR ch -308 va total power integrator overflow 
Found these BBCs: vc01 vc05 vc09
NBBC: 3
Found these SK parameters: 00(BXFNT) 02(LO_TMP) 03(DCAL_T)
RX1 min= 22.90 max= 23.50
RX2 min= 47.50 max= 47.80
RX3 min= 34.10 max= 34.70
Plotting 3 Tsys channels: 01 05 09
Tsys1 values are:   etc
Tsys2 values are:   etc
Tsys3 values are:   etc
NTSYS: 3
in match_chan ft1=  nt1=  st1=  tt= 
set scale tsys1 [2] min max  
set scale tsys2 [2] min max  
set scale tsys3 [2] min max  
 Tsys scale ymin 0 ymax 100