Starting generation of Calibration File 
FS version = 0009.0007.0007 
time_zero = 12067200 
Found #10 errors of type = ERROR sp  -13 This command not supported for your equipment  check equip.ctl. 
Found #2 errors of type = ERROR qo -301 WARNING: ONSOURCE status is SLEWING! 
Found #1 errors of type = ERROR qk -211 Tsys value for device 9u overflowed or was less than zero. 
Found #1 errors of type = ERROR fp  -82 TPI overflowed too many times 
Found #1 errors of type = ERROR vt -201 Tape parameter must be low  or off. 
Found #1 errors of type = ERROR qk -211 Tsys value for device du overflowed or was less than zero. 
Found #1 errors of type = ERROR m5 -900 Check formatter serial number even 
Found #1 errors of type = ERROR fp  -80 TPI Overflowed 
Found #1 errors of type = ERROR qk -211 Tsys value for device eu overflowed or was less than zero. 
Found #1 errors of type = ERROR qk -211 Tsys value for device au overflowed or was less than zero. 
Found #1 errors of type = ERROR qk -211 Tsys value for device bu overflowed or was less than zero. 
Found #1 errors of type = ERROR m5 -906 MARK5 return code 6: inconsistent or conflicting request 
Found #1 errors of type = ERROR qk -211 Tsys value for device cu overflowed or was less than zero. 
Found these BBCs:   
NBBC: 0
Found these RX parameters: 00(BXFNT_) 01(IF_PLT) 03(DCAL_T)
RX1 min= 15.00 max= 2005.139.16:35:02.61
RX2 min= 17.70 max= 18.20
RX3 min= 42.20 max= 42.60
Plotting 0 Tsys channels:   
Tsys values are: 1 2 3 etc
NTSYS: 0