Starting generation of Calibration File 
FS version = 0009.0007.0005 
time_zero = 20271600 
Found #611 errors of type = ERROR an   -5 Error return from antenna. 
Found #294 errors of type = ERROR st   -1 Antenna got the wrong angles 
Found #283 errors of type = ERROR qk -211 Tsys value for device ia overflowed or was less than zero. 
Found #250 errors of type = ERROR st   -2 Commanding antenna failed too many times  giving up. 
Found #123 errors of type = ERROR qo -301 WARNING: ONSOURCE status is SLEWING! 
Found #98 errors of type = ERROR an -102 Pointing computer command angles are incorrect. 
Found #88 errors of type = ERROR qk -211 Tsys value for device ib overflowed or was less than zero. 
Found #25 errors of type = ERROR an -103 Pointing computer tracking errors are too large. 
Found #14 errors of type = ERROR ib   -4 GPIB Device time-out on response c3 
Found #3 errors of type = ERROR m5 -900 Check formatter serial number even 
Found #3 errors of type = ERROR m5 -906 MARK5 return code 6: inconsistent or conflicting request 
Found #3 errors of type = ERROR st   -3 Commanding angles okay now. 
Found #1 errors of type = ERROR mc   -2 Interface b3 responded  but did not ACKnowledge. 
Found #1 errors of type = ERROR ch -351 Tape head 1 is not in requested position. 
Found #1 errors of type = ERROR mc   -2 Interface be responded  but did not ACKnowledge. 
Found #1 errors of type = ERROR ch -349 The Receiver 70K stage is hotter than  80K. 
Found #1 errors of type = ERROR ch -350 The Receiver 20K stage is hotter than  35K. 
Found #1 errors of type = ERROR qk -211 Tsys value for device bu overflowed or was less than zero. 
Found #1 errors of type = ERROR qk -211 Tsys value for device 9u overflowed or was less than zero. 
Found these BBCs: bbc02 bbc06 bbc11
NBBC: 3
Found these RX parameters: 00(front) 02(lo) 03(dcal)
RX1 min= 22.89 max= 28.26
RX2 min= 33.51 max= 39.01
RX3 min= 33.63 max= 39.13
Plotting 3 Tsys channels: 02 06 11
Tsysa values are:    etc
Tsysb values are:    etc
Tsysc values are:    etc
Tsysd values are:    etc
NTSYS: 3
in match_chan ft1=  nt1=  st1=  tt= 
set scale tsys1 [2] min max  
set scale tsys2 [2] min max  
set scale tsys3 [2] min max  
 Tsys scale ymin 0 ymax 100