Starting generation of Calibration File FS version = 0009.0007.0005 time_zero = 5155200 Found #61 errors of type = ERROR qo -301 WARNING: ONSOURCE status is SLEWING! Found #60 errors of type = ERROR an -103 Pointing computer tracking errors are too large. Found #49 errors of type = ERROR ch -349 The Receiver 70K stage is hotter than 80K. Found #49 errors of type = ERROR ch -350 The Receiver 20K stage is hotter than 35K. Found #28 errors of type = ERROR ib -4 GPIB Device time-out on response c3 Found #17 errors of type = ERROR st -3 Commanding angles okay now. Found #17 errors of type = ERROR st -1 Antenna got the wrong angles Found #5 errors of type = ERROR qk -211 Tsys value for device ib overflowed or was less than zero. Found #1 errors of type = ERROR mc -2 Interface b4 responded but did not ACKnowledge. Found #1 errors of type = ERROR qk -211 Tsys value for device ia overflowed or was less than zero. Found #1 errors of type = ERROR mc -2 Interface bb responded but did not ACKnowledge. Found #1 errors of type = ERROR an -102 Pointing computer command angles are incorrect. Found these BBCs: bbc02 bbc06 bbc11 NBBC: 3 Found these RX parameters: 00(front) 02(lo) 03(dcal) RX1 min= -250.0 max= 2005.059.16:40:28.18 RX2 min= 0.061 max= 48.04 RX3 min= 0.061 max= 48.53 Plotting 3 Tsys channels: 02 06 11 Tsys values are: -1 1 2 etc NTSYS: 3 in match_chan ft1= r1164gc.log.tsy1.ntup nt1= 9 st1= 2u tt= 1 set scale tsys1 [2] min max 47.2 198.6 set scale tsys2 [2] min max set scale tsys3 [2] min max set scale tsys4 [2] min max Tsys scale ymin 42.2 ymax 203.6 in match_chan ft1= r1164gc.log.tsy1.ntup nt1= 21 st1= 6u tt= 1 set scale tsys1 [2] min max 47.2 198.6 set scale tsys2 [2] min max set scale tsys3 [2] min max set scale tsys4 [2] min max Tsys scale ymin 32.9 ymax 153.8 in match_chan ft1= r1164gc.log.tsy1.ntup nt1= 15 st1= bu tt= 1 set scale tsys1 [2] min max 47.2 198.6 set scale tsys2 [2] min max set scale tsys3 [2] min max set scale tsys4 [2] min max Tsys scale ymin 55.9 ymax 218.6