Starting generation of Calibration File 
FS version = 0009.0007.0000 
time_zero = 12567600 
Found #193 errors of type = ERROR rl -138 No connection open for that reference address on device r1 
Found #77 errors of type = ERROR RL -138 No connection open for that reference address on device DA 
Found #29 errors of type = ERROR qo -301 WARNING: ONSOURCE status is SLEWING! 
Found #16 errors of type = ERROR rl -138 No connection open for that reference address on device da 
Found #8 errors of type = ERROR ch -500 Previous error prevented checking S2 recorder measured delay. 
Found #8 errors of type = ERROR rl -133 Communications timeout  RCL device probably dead on device r1 
Found #5 errors of type = ERROR st -100 invalid time in antenna message - antenna protocol error. 
Found #4 errors of type = ERROR sp   -4 Unrecognized name (not a function or procedure). 
Found #4 errors of type = ERROR st -403 no response from time counter server 
Found #2 errors of type = ERROR rl  -30 Tape motion state is invalid for requested operation 
Found #2 errors of type = ERROR rz   -2 --C STAT_DIAGDONE: Diagnostic test completed successfully.\n 
Found #2 errors of type = ERROR ma   -4 Device rx timed-out on response. 
Found #2 errors of type = ERROR sc  -12 setcl: FS to computer time difference 0.5 seconds or greater 
Found #2 errors of type = ERROR sc  -10 setcl: failed too many times  couldn't check formatter time 
Found #2 errors of type = ERROR sc  -15 setcl: Cannot determine NTP sync state 
Found #1 errors of type = ERROR st -402 error reading time counter 
Found #1 errors of type = ERROR un  104 Error in antenna communication: Connection reset by peer 
Found #1 errors of type = ERROR st -999 Error in antenna communication 
Found #1 errors of type = ERROR rl -140 Network connection closed by remote host on device r1 
Found #1 errors of type = ERROR st -100 Waiting for antenna response timed out - antenna protocol error. 
Found #1 errors of type = ERROR RL -140 Network connection closed by remote host on device DA 
Found #1 errors of type = ERROR st -999 Failed: processing new source 
Found #1 errors of type = ERROR qk -211 Tsys value for device ve overflowed or was less than zero. 
Found #1 errors of type = ERROR st -999 "Wrap" parameter "ccw" ignored 
Found #1 errors of type = ERROR DA -100 Undefined error code: -100 
Found these BBCs:   
NBBC: 0
Found these  parameters:   
RX1 min= 100000 max= -1
RX2 min= 100000 max= -1
RX3 min= 100000 max= -1
Plotting 0 Tsys channels:   
NTSYS: 0