Starting generation of Calibration File 
FS version = 0009.0005.0003 
time_zero = 1105200 
Found #360 errors of type = ERROR qo -301 WARNING: ONSOURCE status is SLEWING! 
Found #360 errors of type = ERROR an -103 Pointing computer tracking errors are too large. 
Found #145 errors of type = ERROR st   -7 Antenna off-source! 
Found #59 errors of type = ERROR ch -510 Recorder state does not agree with request. 
Found #21 errors of type = ERROR rl -133 Communications timeout  RCL device probably dead on device r1 
Found #6 errors of type = ERROR st   -6 Antenna control restored. 
Found #6 errors of type = ERROR st   -4 Interface not set to remote. 
Found #4 errors of type = ERROR sp  -13 This command not supported for your equipment  check equip.ctl. 
Found #4 errors of type = ERROR rt -201 Position must be a number  "reset"  "unk" or "uns". 
Found #2 errors of type = ERROR ch -500 Previous error prevented checking S2 recorder measured delay. 
Found #1 errors of type = ERROR st   -5 Error return from antenna. 
Found #1 errors of type = ERROR rz   -2 --C STAT_DIAGDONE: Diagnostic test completed successfully.\n 
Found #1 errors of type = ERROR bo -301 Error decoding error number in TNX. 
Found #1 errors of type = ERROR ma   -4 Device rx timed-out on response. 
Found #1 errors of type = ERROR rz  -51 EFC STAT_RPMONBOTEOT: Encountered EOT (end of tape) during\nautomatic record (transport 0). All tapes have been stopped.\n 
Found #1 errors of type = ERROR rl  -56 Tape motion state is inconsistent or illegal 
Found #1 errors of type = ERROR rz  -57 EF- STAT_INSTATE: Tape motion state is inconsistent or illegal.\n 
Found these BBCs:   
NBBC: 0
Found these SX parameters: slo xlo sup
RX1 min= 3.74 max= 2005.012.21:11:56.24
RX2 min= 4.66 max= 4.68
RX3 min= 261.36 max= 267.71
Plotting 0 Tsys channels:   
NTSYS: 0