Starting generation of Calibration File 
FS version = 0009.0007.0007 
time_zero = 22780800 
Found #374 errors of type = ERROR ST   -9 Antenna is in MANUAL mode. 
Found #373 errors of type = ERROR ST   -6 Antenna brakes are ON. 
Found #80 errors of type = ERROR qk -211 Tsys value for device 8u overflowed or was less than zero. 
Found #9 errors of type = ERROR qo -301 WARNING: ONSOURCE status is SLEWING! 
Found #9 errors of type = ERROR AN -103 Pointing computer tracking errors are too large. 
Found #4 errors of type = ERROR qk -211 Tsys value for device cu overflowed or was less than zero. 
Found #2 errors of type = ERROR qk -211 Tsys value for device bu overflowed or was less than zero. 
Found #1 errors of type = ERROR mc   -2 Interface bb responded  but did not ACKnowledge. 
Found these BBCs: bbc01 bbc05 bbc09
NBBC: 3
Found these RX parameters: 00(front) 02(lo) 03(dcal)
RX1 min= 29.24 max= 39.50
RX2 min= 47.80 max= 54.15
RX3 min= 50.85 max= 54.76
Plotting 3 Tsys channels: 01 05 09
Tsys values are: -1 1 2 etc
NTSYS: 3
in match_chan ft1= c0509ap.log.tsy1.ntup nt1= 8 st1= 1u tt= 1
set scale tsys1 [2] min max 55.0 77.4
set scale tsys2 [2] min max  
set scale tsys3 [2] min max  
set scale tsys4 [2] min max  
 Tsys scale ymin 50.5 ymax 80.1 
in match_chan ft1= c0509ap.log.tsy1.ntup nt1= 18 st1= 5u tt= 1
set scale tsys1 [2] min max 55.0 77.4
set scale tsys2 [2] min max  
set scale tsys3 [2] min max  
set scale tsys4 [2] min max  
 Tsys scale ymin 41.3 ymax 68 
in match_chan ft1= c0509ap.log.tsy1.ntup nt1= 12 st1= 9u tt= 1
set scale tsys1 [2] min max 55.0 77.4
set scale tsys2 [2] min max  
set scale tsys3 [2] min max  
set scale tsys4 [2] min max  
 Tsys scale ymin 61.5 ymax 126.9