Starting generation of Calibration File 
FS version = 0009.0007.0007 
time_zero = 22176000 
Found #710 errors of type = ERROR qk -211 Tsys value for device ve overflowed or was less than zero. 
Found #48 errors of type = ERROR AN   -4 Interface not set to remote. 
Found #40 errors of type = ERROR qo -301 WARNING: ONSOURCE status is SLEWING! 
Found #12 errors of type = ERROR ch -371 IF3 alarm is on 
Found #11 errors of type = ERROR st -403 no response from time counter server 
Found #8 errors of type = ERROR ch -309 v3 alarm is on 
Found #5 errors of type = ERROR sp   -4 Unrecognized name (not a function or procedure). 
Found #3 errors of type = ERROR ch -309 vc alarm is on 
Found #3 errors of type = ERROR ch -308 va total power integrator overflow 
Found #3 errors of type = ERROR st -100 Waiting for antenna response timed out - antenna protocol error. 
Found #3 errors of type = ERROR st -999 Antenna STOP command failed!!! 
Found #3 errors of type = ERROR ch -309 vb alarm is on 
Found #3 errors of type = ERROR ch -309 vd alarm is on 
Found #2 errors of type = ERROR qk -211 Tsys value for device v4 overflowed or was less than zero. 
Found #2 errors of type = ERROR st -999 Failed: stopping antenna motion 
Found #2 errors of type = ERROR st -100 wrong OK STOP message - antenna protocol error. 
Found #2 errors of type = ERROR sp   -3 More than 12 characters in function or procedure name. 
Found #1 errors of type = ERROR ch -317 Total power integrator overflow on IF2 
Found #1 errors of type = ERROR st -999 Error in antenna communication 
Found #1 errors of type = ERROR un  104 Error in kopmn communication: Connection reset by peer 
Found #1 errors of type = ERROR ch -369 IF3 lo is unlocked. 
Found #1 errors of type = ERROR st -999 Failed: closing antenna communication 
Found these BBCs: vc01 vc05 vc09
NBBC: 3
Found these  parameters:   
RX1 min= 100000 max= -1
RX2 min= 100000 max= -1
RX3 min= 100000 max= -1
Plotting 3 Tsys channels: 01 05 09
Tsys1 values are:   etc
Tsys2 values are:   etc
Tsys3 values are:   etc
NTSYS: 3
in match_chan ft1=  nt1=  st1=  tt= 
set scale tsys1 [2] min max  
set scale tsys2 [2] min max  
set scale tsys3 [2] min max  
 Tsys scale ymin 0 ymax 100