Starting generation of Calibration File 
FS version = 0009.0006.0009 
time_zero = 5418000 
Found #202 errors of type = ERROR qk -211 Tsys value for device ve overflowed or was less than zero. 
Found #4 errors of type = ERROR ch -317 Total power integrator overflow on IF2 
Found #3 errors of type = ERROR ch   -4 Device v7 timed-out on response from MATCN 
Found #2 errors of type = ERROR ch -301 vf module is not in remote 
Found #1 errors of type = ERROR ch -309 v7 alarm is on 
Found #1 errors of type = ERROR ch -309 vf alarm is on 
Found #1 errors of type = ERROR ch -302 v7 frequency does not check with requested value 
Found #1 errors of type = ERROR ch -304 v7 TPI selection does not check with requested setting 
Found #1 errors of type = ERROR ch -309 vb alarm is on 
Found #1 errors of type = ERROR ch -306 v7 LSB attenuator does not check with requested setting 
Found #1 errors of type = ERROR ch -305 v7 USB attenuator does not check with requested setting 
Found #1 errors of type = ERROR ma   -4 Device vf timed-out on response. 
Found #1 errors of type = ERROR ch -303 v7 bandwidth does not check with requested value 
Found these BBCs: vc06 vc11 
NBBC: 2
Found these RX parameters: 00(front) 01(rear) 02(lo)
RX1 min= 18.37 max= 2004.062.17:27:10.06
RX2 min= 31.80 max= 46.45
RX3 min= 42.06 max= 50.12
Plotting 2 Tsys channels: 06 11 
Tsys values are: 1 2 3 etc
NTSYS: 2
in match_chan ft1= crds10ho.log.tsy1.ntup nt1= 20 st1= 6u tt= 1
set scale tsys1 [2] min max 47.1 76.4
set scale tsys2 [2] min max  
set scale tsys3 [2] min max  
set scale tsys4 [2] min max  
 Tsys scale ymin 29.6 ymax 70.3 
in match_chan ft1= crds10ho.log.tsy1.ntup nt1= 14 st1= bu tt= 1
set scale tsys1 [2] min max 47.1 76.4
set scale tsys2 [2] min max  
set scale tsys3 [2] min max  
set scale tsys4 [2] min max  
 Tsys scale ymin 50 ymax 83.9