Starting generation of Calibration File 
FS version = 0009.0004.0006 
time_zero = 2469600 
Rack type is MK3/4
Rack type is MK3/4
Rack type is MK3/4
Found #23 errors of type = ERROR qd -301 Synch block CRC checksum test FAILED. 
Found #13 errors of type = ERROR ch -351 Tape head 1 is not in requested position. 
Found #8 errors of type = ERROR qo -301 WARNING: ONSOURCE status is SLEWING! 
Found #3 errors of type = ERROR sc   -2 setcl: formatter time out-of-range 
Found #2 errors of type = ERROR ch -345 Tape drive alarm is on 
Found #1 errors of type = ERROR ch -342 Tape is not in ready state (vacuum not ready) 
Found #1 errors of type = ERROR qg -303 Track 10 parity errors exceed threshold. 
Found #1 errors of type = ERROR ch -334 Tape should be moving and it's stopped 
Found #1 errors of type = ERROR ch -317 Total power integrator overflow on IF2 
Found these BBCs: vc02 vc06 vc11
NBBC: 3
Found these RX parameters: 02(LO) 03(DCAL) 0E(LO5MHZ)
RX1 min= 29.36 max= 32.29
RX2 min= 46.70 max= 46.94
RX3 min= 2.500 max= 2.500
Can't plot RX3
Plotting 3 Tsys channels: 02 06 11
Tsys1 values are: 1 2 etc
Tsys2 values are: 9 10 etc
Tsys3 values are:   etc
NTSYS: 3
in match_chan ft1= is147wz.log.tsy1.ntup nt1= 7 st1= v2 tt= 1
set scale tsys1 [2] min max 59.2 128.4
set scale tsys2 [2] min max 46.4 87.2
set scale tsys3 [2] min max  
 Tsys scale ymin 60.3 ymax 100 
in match_chan ft1= is147wz.log.tsy1.ntup nt1= 11 st1= v6 tt= 1
set scale tsys1 [2] min max 59.2 128.4
set scale tsys2 [2] min max 46.4 87.2
set scale tsys3 [2] min max  
 Tsys scale ymin 54.5 ymax 100 
in match_chan ft1= is147wz.log.tsy2.ntup nt1= 8 st1= v11 tt= 2
set scale tsys1 [2] min max 59.2 128.4
set scale tsys2 [2] min max 46.4 87.2
set scale tsys3 [2] min max  
 Tsys scale ymin 46.4 ymax 87.2