Starting generation of Calibration File 
FS version = 0009.0004.0006 
time_zero = 6606000 
Rack type is VLBA
Found #78 errors of type = ERROR qo -302 WARNING: ANTCN not being run  antenna device is  dev null. 
Found #78 errors of type = ERROR qs -306 WARNING: ANTCN not being run  antenna device is  dev null. 
Found #68 errors of type = ERROR ib -306 GPIB(eabo) I O operation aborted  RD 
Found #45 errors of type = ERROR qk -211 Tsys value for device ic overflowed or were less than zero. 
Found #35 errors of type = ERROR ib -306 GPIB(eabo) I O operation aborted  WF 
Found #13 errors of type = ERROR qg -305 AUX data differs from expected value on track 12. 
Found #13 errors of type = ERROR qg -305 AUX data differs from expected value on track  8. 
Found #13 errors of type = ERROR qg -305 AUX data differs from expected value on track  4. 
Found #13 errors of type = ERROR qg -305 AUX data differs from expected value on track 28. 
Found #13 errors of type = ERROR qg -305 AUX data differs from expected value on track 20. 
Found #13 errors of type = ERROR qg -305 AUX data differs from expected value on track 16. 
Found #13 errors of type = ERROR qg -305 AUX data differs from expected value on track 24. 
Found #12 errors of type = ERROR qg -305 AUX data differs from expected value on track 29. 
Found #12 errors of type = ERROR qg -305 AUX data differs from expected value on track 21. 
Found #12 errors of type = ERROR qg -305 AUX data differs from expected value on track 17. 
Found #12 errors of type = ERROR qg -305 AUX data differs from expected value on track 25. 
Found #12 errors of type = ERROR qg -305 AUX data differs from expected value on track 13. 
Found #12 errors of type = ERROR qg -305 AUX data differs from expected value on track  9. 
Found #12 errors of type = ERROR qg -305 AUX data differs from expected value on track  5. 
Found #4 errors of type = ERROR qd -302 Decode command only supports Mark III decoder. 
Found #2 errors of type = ERROR ch -233 rc tape drive should be moving and it isn't 
Found #2 errors of type = ERROR sp   -4 Unrecognized name (not a function or procedure). 
Found #2 errors of type = ERROR bo -107 No parameter was specified for this switch 
Found #1 errors of type = ERROR mc   -2 Interface bc responded  but did not ACKnowledge. 
Found #1 errors of type = ERROR rc -201 Parameter must be reboot load unload bot eot release <feet> feet or zero. 
Found #1 errors of type = ERROR qg -303 Track 22 parity errors exceed threshold. 
Found #1 errors of type = ERROR bo -105 Error opening schedule file FMP  FFF 
Found these BBCs:   
NBBC: 0
Found these  parameters:   
RX1 min= 100000 max= -1
RX2 min= 100000 max= -1
RX3 min= 100000 max= -1
Plotting 0 Tsys channels:   
Tsysa values are: 1 2 3 etc
Tsysb values are: 9 10 11 etc
Tsysc values are:    etc
Tsysd values are:    etc
NTSYS: 0