Starting generation of Calibration File 
FS version = 0009.0004.0014 
time_zero = 28771200 
Rack type is VLBA
Found #198 errors of type = ERROR qk -211 Tsys value for device ia overflowed or were less than zero. 
Found #16 errors of type = ERROR qo -301 WARNING: ONSOURCE status is SLEWING! 
Found #15 errors of type = ERROR an -103 Pointing computer tracking errors are too large. 
Found #3 errors of type = ERROR ch -208 be gain mode does not check with requested setting 
Found #2 errors of type = ERROR qk -211 Tsys value for device ib overflowed or were less than zero. 
Found #1 errors of type = ERROR an -102 Pointing computer command angles are incorrect. 
Found #1 errors of type = ERROR mc   -2 Interface be responded  but did not ACKnowledge. 
Found #1 errors of type = ERROR sp   -4 Unrecognized name (not a function or procedure). 
Found these BBCs: bbc02 bbc06 bbc11
NBBC: 3
Found these RX parameters: 00(front) 02(lo) 03(dcal)
RX1 min= 16.78 max= 23.26
RX2 min= 45.72 max= 47.55
RX3 min= 47.07 max= 47.92
Plotting 3 Tsys channels: 02 06 11
Tsysa values are: 1 2 3 etc
Tsysb values are: 9 10 11 etc
Tsysc values are:    etc
Tsysd values are:    etc
NTSYS: 3
in match_chan ft1= c1006gc.log.tsy1.ntup nt1= 7 st1= 2u tt= 1
set scale tsys1 [2] min max 60.0 250.9
set scale tsys2 [2] min max 39.1 133.4
set scale tsys3 [2] min max  
 Tsys scale ymin 61.7 ymax 100 
in match_chan ft1= c1006gc.log.tsy1.ntup nt1= 11 st1= 6u tt= 1
set scale tsys1 [2] min max 60.0 250.9
set scale tsys2 [2] min max 39.1 133.4
set scale tsys3 [2] min max  
 Tsys scale ymin 51.2 ymax 100 
in match_chan ft1= c1006gc.log.tsy2.ntup nt1= 8 st1= 11u tt= 2
set scale tsys1 [2] min max 60.0 250.9
set scale tsys2 [2] min max 39.1 133.4
set scale tsys3 [2] min max  
 Tsys scale ymin 39.1 ymax 100